Accelerated Curing Tank

Accelerated Curing Tank: MTCT-01

Accelerated Curing tank shall be constructed from any material of suitable strength that will resist the effect of corrosion. Internal dimension should be adequate to accommodate the required number and size of test specimen. The tank shall contain sufficient water and be controlled so that temperature of water around the specimen immersed in the tank is maintained at the desired level.

EXPERIMENTAL PROGRAM– To get the early age strength through accelerated curing, warm water method was adopted. In this method, after the casting of cubes, specimen was cured at normal temperature for 24 hours and then put in accelerated tank on second day with temperature 80˚C for 5 hours and then 80˚C to falling temperature up to next day. After this period of curing, concrete cube specimen was tested for compressive strength and results are co-related with 28 and 56 days compressive strength of standard water curing. This co relation of accelerated strength and normal curing strength is achieved for all types of cement. To find the confident level of these relation seven different types of cement were used. The composition of different types of Cement is given in table IV. For each type of cement four different were used. Mix design was prepared by ACI method.

Features:-

Durable finish
Elevated strength
Robust construction
Accelerated curing tank
Compression Testing Machine
Rectangular double walled metal cabinet
Easy to replace high wattage heater
Even circulation of water to maintain the uniform temperature
Variable heating temperature with supply indication
Precise thermal gradient and curing time
Ideal for measuring the strength and compression resistance of various substrates
Insulated and leakage-free water tank with high capacity
Easy to operate and clean

Description

Technical Specification:-

Voltage 220 V/440 V
Driven Type Electric
Frequency 50 Hz
Power supply: 220-240V 1ph 50/60 Hz 4500W
Temperature range from ambient to 100 °C
The separate control panel is provided with a thermoregulatory, timer, pilot lights, main switch
The test consists essentially in curing the concrete specimens with water heated by 3 electric elements of 1500W each
In side all from stainless steel, outside from steel painted sheet with an intermediate layer of insulating mineral wool.
Temperature controller cum indicator
Water circulation pump
Calibration certificate is provided for digital controller

Optional Accessories:-

Rubber hand Gloves
Spare Heaters
Accelerated Curing Autoclave By Steam Pressure
Accelerated Curing Drier : By Dry Heat
In built refrigeration system for curing at 27 deg C
Low water Level cut off device to safeguard heaters against low water level burn out

** Note:-The content of the product and specification are subject to change without prior notice for continuous improvement. Images shown are for representation purpose only. “MICROTEKNIK” keeps the right to modify the content in the product without prior notice.